9
Assembly
Attaching the Discharge Chute
1. Attach the discharge chute and handle to the snow thrower by
placing it on the chute seat on the snow thrower, aligning the
holes in three places and pushing a bolt from the inside out,
through the chute and chute handle and securing with a nylon
lock nut on the exterior (see Figure 4). The distance snow is
thrown can be adjusted by changing the angle of the chute tilt
by loosening the wing knob found on the left side of the chute
assembly. Pivot the chute upward or downward then retighten
the wing knob.
SKID
SHOE
HEX NUT
(2 PLACES)
Adjusting the Skid Shoes
1. Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when operating
on gravel or crushed rock surfaces. Loosen the two hex nuts that
retain the skid shoe in place and move up or down as desired,
then retighten the lock nuts (see Figure 5). Repeat for the
opposite side of the snow thrower.
Figure 5
CHUTE
SEAT
DISCHARGE
CHUTE
NYLON LOCK NUT
& BOLT
(3 PLACES)
Figure 4
CHUTE
TILT
HANDLE
