CARPET/UPHOLSTERY CLEANING
7
Plug cord into electrical
outlet.
1.
Turn ON/OFF switch to
the “ON” position.
2.
Gently scrub the stained area with
the brush on the tool until the stain
is completely removed. Release
the solution dispense trigger and
continue moving the tool over
cleaned area to remove as much
liquid as possible.
4.
Hold the tool approximately 1”
above the stained surface. Press the
solution dispense trigger to apply
cleaning solution to the stained
area.
NOTE:
It may be necessary to
prime the pump prior to the first
use. To do this, continuously
depress Solution Dispense Button
until a steady stream of solution
comes out of Spray Nozzle.
3.
IMPORTANT:
DO NOT USE THE CARPET SHAMPOOER AS A DRY VACUUM.
NOTE:
Never leave unit unattended with power on. Turn OFF when emptying and filling reservoir. DO NOT oversaturate
carpet or upholstery.
IMPORTANT:
FOR BEST CLEANING RESULTS, USE STEADY, MODERATE, FORWARD AND BACKWARD MOTION.
CHECK FOR COLOR FASTNESS:
Before cleaning carpet/upholstery, test for color fastness. Dampen a white cloth with solution. Test a small area in
a closet or under a cushion. Gently rub the cloth over the area. Check each color for color bleeding. If the cloth
remains clean, it should be safe to clean the carpet/upholstery.
HELPFUL HINTS FOR CLEANING CARPET:
1. Do not oversaturate carpet with cleaning solution while using the Carpet Shampooer.
2. For heavily soiled areas, additional applications may be necessary.
3. Allow plenty of time to dry carpet thoroughly.
4. Wipe cleaning solution from woodwork and wood to prevent any damage.
5. Try not to walk on carpet until it is completely dry.
6. After carpet is thoroughly dry, vacuum the carpet using a cleaner with a revolving brushroll.
8
EMPTYING AND CLEANING THE DIRTY WATER TANK
Turn ON/OFF switch to
the OFF position. Unplug
power cord from outlet.
Press down on the Lid
Release Latch and tilt
towards front of cleaner
to access the tanks.
Remove Clean and Dirty
Water Tank assembly by
pulling up and out of
cleaner and separate
Dirty Water Tank.
Open Dirty Water Tank plug and empty
contents into sink (Diagram 3). Rinse
thoroughly with clean water (Diagram
3a). Replace Dirty Water Tank plug and
return tank to cleaner.
1.
3a.
2.
3.
LID RELEASE
LATCH
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY - UNPLUG BEFORE REMOVING TANK(S) AND
REMOVE TANKS FROM UNIT BEFORE EMPTYING.
When to empty:
- Dirty water reaches the “full” line on the dirty water tank - OR
- Float shuts off airflow, indicated by a change in pitch of the motor and reduced suction
- At end of each use - prior to storage
HOW TO STORE CLEANER
WARNING:
DO NOT STORE APPLIANCE IN GARAGE OR WHERE UNIT COULD FREEZE.
1. Wipe all surfaces with a soft cloth.
2. Wrap power cord around cord hooks on back of cleaner.
3. Secure attachment hose around upper and lower hose wraps.
4. Store unit in a dry area at room temperature.
