CaUTiOn
Don’t over saturate your upholstery.
REmOvE AND REPlACE THE BElT
OR BRUSHBAR
1. Remove the dirty water
and clean water tank.
Switch off and unplug
the carpet washer. Flip
the cleaner on it’s side to
expose the nozzle base.
To remove the belt cover,
use a phillips screwdriver
to remove the two screws.
2. Hold the belt cover near
the belt roll and lift out.
3. Grasp the brushbar with
one hand, using the other
hand to keep tension
on the the belt while
removing.
4. Lift brushbar while
pulling it out.
5. Slide the belt off the the
motor shaft and dispose.
When replacing the belt,
first slide it onto the
motor shaft. Then slip
the brushbar through the
belt. Place the belt in the
area of the brush without
bristles.
Slide the brushbar into the
nozzle, ensuring that the
brushbar end caps line up
correctly.
Manually turn the brushbar
to check that it is fitted
properly.
Replace the belt cover by
inserting the end furthest
from the brush first. Then
replace the front of the
belt cover before securing
in place with the two
screws.
16
