6
Setup and
Operations
Before using the ZXT-120, please read the [INSTALLATION] if you need to mount the
ZXT-120 to a wall. Power up the ZXT-120 by the USB Power 5Vdc or Dry battery AAA x
3pcs.
- Plug-in 5Vdc power into the USB socket if operated at Always Listening mode. Or
- Install 3xAAA batteries if operated at FLiRS mode.
- Please refer to the section of [MOUNTING PROCEDURE].
- Remove the battery cover on the back of your ZXT-120 battery chassis.
- Mount the battery cover into the main unit with 2 screws.
- Check the polarity of the batteries and the "+/-" marks inside the battery compartment.
- Insert the batteries.
- Push the battery cover and main unit back in place.
(Please carefully read through the following then store the manual for future reference.)
Listening Mode (default mode is FLiRS)
ZXT-120 can be configured as either "
Frequently Listening Routing Slaves
" FLiRS (if
you are using battery) or "
Always Listening
" (if you are using 5Vdc adaptor) before
inclusion process. Refer to Glossary for definition of "FLIRS" and "Always Listening"
mode.
Important:
It is not allowed to changing ZXT-120 listening mode without exclusion process (do not
change ZXT-120 listening mode while ZXT-120 is included in a network).
ƒ{
- Use new batteries of the recommended type and size only.
ƒ{
- Never mix used and new batteries together.
ƒ{
- To avoid chemical leaks, remove batteries from the ZXT-120 if you do not intend to
use the remote for an extended period of time.
- Dispose of used batteries properly; do not burn or bury them.
CAUTION (battery and power adaptor safety)
