9
Basic Operation
Preview Stream (UDP, RTP)
When the ZyPerMX4/MX2 is configured to output UDP or RTP multicast IP streams; it can also
simultaneosly send out a Unicast motion JPEG that can be used for other purposes such as a
preview stream in a 3rd control appliction.
1.
Configure the ZyPerMX2/4 for UDP or RTP streaming as detailed in the prior section.
2.
Point a connected web browser such as Chrome to the IP address of the ZyPerMX2/4 with
the following port information to view the motion JPEG stream.
IP_ADDRESS:8080/port_#.mjpg
IP_ADDRESS = The IP Address of the ZyPerMX2 or ZyPerMX4
Note that the ZyPerMX4 has two IP Addresses. One address for ports 1 & 2 and
another address for ports 3 & 4
port_# = This is the phyical port number on the ZyPerMX2 or ZyPerMX4. The ZyPerMX2
has 2 ports and the ZyPerMX4 has 4 ports.
Example:
http://192.168.0.26:8080/port_2.mjpg
3.
Note that this preview stream is a lower resolution than the primary UDP or RTP stream and
the frame rate will be 30fps. This stream is also Unicast. The system can support several
simultaneous Unicast streams, but the number is not unlimited.
4.
Note, the preview stream is only availble if selecting UDP or RTP streaming. It is not
availalbe if selecting “UDP+HLS” or “RTP+HLS”.
