Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
Rev.: 20160908
Installation Type 2a (with CHTHD1/THCHD1 T-Harness)
Page 6
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
10
DBALL2
Prog. Button
LED
4
14
12
2
Twisted pair in the steering column or behind radio
White/Orange
White/Gray, White,
White/Pink or White/Black
RF
FT CAN High:
Orange/Green:
5
FT CAN Low:
Orange/Brown:
6
[1]
(-) Parking Lights:
Green/Black:
2
(-) Driver Door Trigger
Violet wire in
driver kick panel or
driver door (Jeeps ONLY)
RAP Off:
Yellow/Black:
10
[1]
Parking Light MUX Output:
Violet/Green:
8
[1]
Parking Light MUX Output:
Violet/Brown:
9
See page 8 for
wiring information
TX
(-) Ground
RX
(+) 12V
OR
6:
White/Black:
(-) Hood
Hood Pin
Remote Start Safety
Override Switch
CHTHD1/
THCHD1
(optional)
12-pin Connector
(Vehicle side)
Ignition
Barrel
(vehicle side)
12-pin Connector
(harness side)
12-pin Connector
(harness side)
You can connect to either a XL202
RFTD
OR
a SmartStart module.
Refer to the
SmartStart/XL202
Installation Notes
for more information.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
[1]
See Parking Lights wiring reference chart for the appropriate Parking Lights configuration.
Wires not listed in this diagram are not required for the installation.
This guide supports the installation of a DBALL in Remote Start Ready (RSR) mode with or without a
Plug & Play (
CHTHD1
or
CHTHD2
) T-Harness (Optional). This solution offers three (3) configuration
options to control your system: 3x OEM Lock Remote Start Activation, RF Kit or SmartStart
(all sold separately).