Directed Xpresskit DBALL2, Manual, Page: 23 / 28

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
Rev.: 20160908
LED Diagnostics & Troubleshooting
Page 23
LED Status Description Troubleshooting
Module Programming
Off Module has no power. Check the power connections.
Solid red The bus type cannot be detected.
Make sure the connections to the data bus are correct and
insert the key in the ignition switch.
Flashes orange
The vehicle type cannot be
detected. Insert the key in the ignition switch and turn to the ON position.
You may need to wait up to 10 seconds.
Flashes green Waiting for keyless.
Remove the key from the ignition switch and press a keyless
button.
Solid green for 3
seconds
Module was successfully
programmed or is already
programmed.
Normal operation.
Solid orange for 3
seconds Module was successfully
programmed without diagnostics.
Normal operation.
Active Ground While Running
Flashes green
GROUND OUT ON (GWR)
command received.
Otherwise, the Ground While Running (status) signal
was lost or was never received by the module.
Commands can come from RF, D2D or W2W.
Flashes red & orange IGNITION ON command received.
Otherwise, the ignition signal was not received by the
module. In a W2W install, it will show only if the ignition
input wire is used.
Flashes green quickly START ON command received.
Otherwise, the start signal was not received by the
module. In a W2W install, it will show only if the ignition
input wire is used.
Inactive Ground While Running
Flashes orange x1 Lock command has been received
Flashes orange x2
Unlock command has been
received
Flashes orange x3 Trunk command has been received
Flashes orange x4 AUX1 command has been received
Flashes orange x5 AUX2 command has been received
External Module Synchronization
Flashes red, red and
orange x10 OBDII feature not supported.
Diagnostic data bus not detected.
Some features are not supported by SmartStart. This can be
caused by missing wire connections or module hardware
limitation. Refer to the wiring installation section to check the
connections.
RSR Code
Flashes red x 7
3x OEM Lock Remote Start
Activation was attempted when
RFTD feature is disabled. Activated from Web automatically when using RSR flash tool or
can be done manually. Refer to feature programing section for
more information.
Normal operation.
Solid red
Flashes
green
Flashes
green
Flashes
red &
orange
Flashes
green
quickly
Flashes
orange
Flashes
orange x1
Flashes
orange x2
Flashes
orange x3
Flashes
orange x4
Flashes
orange x5
Solid green
x3 secs
Solid orange
x3 secs
Off
Flashes red
x7
(Flashes red,
red, then
orange) x 10
This guide supports the installation of a DBALL in Remote Start Ready (RSR) mode with or without a
Plug & Play (
CHTHD1 or CHTHD2 ) T-Harness (Optional). This solution offers three (3) configuration
options to control your system: 3x OEM Lock Remote Start Activation, RF Kit or SmartStart
(all sold separately).