Directed VW02, Firmware Specific Manual, Page: 13 / 43

13
Directed Digital System VW02
© 2016 Directed. All rights reserved.
Type 3 - Regular Key
Refer to "Vehicle wiring reference charts" on page 23 for more information on vehicle-specific connections.
[2]
(+) Siren Output: Brown : 17
Siren
Hood Pin
FT CAN High: Orange/Green : 7
FT CAN Low: Orange/Brown : 8
(-) Hazards SW Output: Green/Black: 10
B C A
VESCM - Driver side under dashboard
10: Red : (+) 12V (+) 12V
9: Black : (-) Ground (-) Ground
Steering Column Control Unit
12 29
28
42 25 1
52 41 24 11
FT CAN Low: Orange/Brown , pin 3
(+) Ignition:
Black , pin 14
[5]
(+) Starter: pin 6
FT CAN High: Orange/Green , pin 4
[4]
Clutch Output: Dk.Blue : 7
[1]
(-) Hood Input: Gray : 3
(+) Starter Output: Green/Red: 14
2: White/Brown: (+) Ignition Output
1: White: (+) 12V
C plug (Brown)
at VESCM
(-) Hazards: Brown/Red , pin 7
(connect this wire only if turn
signals don’t work on CAN)
[4],[5]
(-) Clutch: pin 30
4: Yellow/Red : Key Wrap
[3]
5: Orange/Red : Key Wrap
[3]
3: Brown/Red : Key Wrap
[3]
6
14
1 8
9 16
The Remote Start
Safety Override
Switch
MUST be in
the ON position.
Remote Start Safety
Override Switch
With the exception of the OBDII diagnostic connector, all connectors are displayed from the wire side (unless specified otherwise).
[1]
The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin.
[3]
For Key Wrap instructions refer to pages 7-10.
[4]
For manual transmission vehicles only.
16 Black
3 Wh
4 White
12 White
4 Red
7 White
2 Wh
2 Bk
6 Gr
een
18 White
Manual/Auto. Transmission Type
Prog.
Button
Manual/Auto. Transmission Type
Prog.
Button
[5]
For wire colors, refer to the Vehicle Wiring Reference Chart on page 23.
[2]
The siren is only compatible with Directed Digital Hybrid Systems.
30
86
85
87
87a
(+) 12V
Fuse 5A
(+) Brake: Black/Red , pin 17
Note: Connect only on vehicle
where brake needs to be
depressed to start.