16
Directed Digital Solutions FORD5
© 2016-03-17 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 18 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note:
To skip the transponder programming and use convenience features only, press the
programming button 5 times. The LED will flash orange then proceed to step 5.
Must be connected LAST
&
Solid
Driver's door must be opened during programming.
4
Open the remote. Remove the battery. Re-assemble the remote.
Hold the key up to the right side of the steering column. There will be a slot to insert the key
into or a symbol to hold it up against.
Remove
battery
5
Press the Push-To-Start (PTS) button to turn the ignition ON. The LED starts flashing green.
Note:
If transponder programming was skipped, the LED turns ON solid orange for 3
seconds then shuts OFF when programming is done. Press the PTS button to turn the ignition
OFF and proceed to step 11
&
Flashes
6
Press the PTS button to turn the ignition OFF. The LED keeps flashing green.
&
Flashes
7
Wait until the LED turns on solid orange (Approximately 10 seconds).
&
Flashes
10 sec
Solid
8
Press the PTS button to turn the ignition ON. The LED starts flashing orange slowly.
&
Flashes
slowly
9
Turn
vehicle ignition OFF.
10
Disconnect the module and complete the
Key2GO
procedure (see below).
11
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
12
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, refer to the Analog Installation Guide, which can be found on
www.directechs.com.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.