©
2013
Directed. All rights reserved.
23
Troubleshooting
The 535T will not go into programming mode
.
Verify that the window switch input wires are connected correctly. It may be necessary to verify that
the window switch input wire is receiving (+) or (-) when you activate the corresponding window
switch. Also, make sure the vehicle’s key is in the ON position. If the vehicle is equipped with a
push button ignition/start system, place the car into an ignition mode that allows the windows to
operate normally.
The windows do not move, and the 535T’s fuse blows.
The switch side and the motor side connections may be reversed. Always make these determinations
while using the master switch (if there is one), and cut both wires before testing if any uncertainty exists.
The window moves an inch or so, and stops
.
Does the vehicle have a one-touch module? if so, make sure that the switch wires are connected at
the window switch and the motor wires are connected at the window motor.
Is the window too efficient or inefficient? If you help the window up does it move the entire
direction? If so, you may need to reprogram the 535T.
One window works fine, but the other does not move
.
Does the window in question have a one-touch module? if so, make sure that the switch wires are
connected at the window switch and the motor wires are connected at the window motor.
I can’t find any wires on the switch that seem to work
.
Some newer vehicles use unusual window control modules. Many of these require the 535T wires
to be run into each door. If you are unsure, call Directed Tech Support for details.
My siren triggers while the 535T is rolling up/down the windows
.
Be sure to place the 535T far away from any impact sensor to keep from triggering the security
system. If this does not help refer to the following diagram to prevent the security from false
triggering when the 535T is controlling the windows.
