©
2013
Directed. All rights reserved.
15
535T Programming
When installation is complete the 535T will need to be programmed to learn the window threshold
of the vehicle.
To program the 535T make sure that dipswitch 1 is in the OFF (2 window) position.
Enter Learn Routine (2 window mode)
1. With the vehicle’s ignition on, temporarily connect the Aux channel input (H2/3 Red/White)
wire to ground. This wire must remain grounded during the entire learn procedure.
2. While the H2/3 Red/White is receiving a ground input, attempt to roll the driver window up
from the master window switch. The window should not roll up. If you have wired the 535T
so that one-touch functionality can operate from each door, this step must be performed at
that door (if installed for rear window control).
3. Continue holding the driver side window “up” switch until the window starts to close, this
should take two to three seconds. If the window does not begin to move, verify that the H2/1
Brown input is receiving (+) or (-) when you press the switch and that the polarity dip switch
is set to the appropriate position.
4. The windows now begin to close and then open a few times one by one while the 535T
attempts to learn the “fully opened” and “fully closed” positions.
5. Once the learn procedure has completed both windows close and then vent to indicate a
successful learn routine.
Exit Learn Routine
The learn routine is immediately canceled and stops window travel under any of the following
conditions:
• H2/3 Red/White ground ceases
• Any window switch is pressed after learn routing has begun
• If the window learn procedure detects a window failure or is unable to detect the “fully
opened” or “fully closed” positions.
