11
403.SUBARU2 1.38 2010 Subaru Outback
©2022 VOXX•DEI LLC. All rights reserved.
Module programming
For
Convenience-Only
programming, see next section.
1
Ensure vehicle is in a safe location and cannot move forward during programming. For
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
2
The harnesses must be connected in this exact order:
Connect the 14-pin.
1.
Connect the 12-pin.
2.
Connect the 10-pin.
3.
When the LED turns on solid red, proceed with the next step.
3
Insert and turn the key to the ON position.
The LED will flash orange, then green.
4
Within 3 seconds, but no more than 10 seconds, start the vehicle by turning the key.
The LED will turn ON solid green for 3 seconds and then turn OFF.
1.
Turn vehicle ignition OFF.
Programming is completed.
2.
Note: If the LED flashes orange slowly, turn the ignition OFF and proceed with Step 4.
5
Remove the module from the vehicle and reconnect it to your computer.
The Directechs website will automatically recognize that you are moving to the second
phase of the programming sequence.
1.
Click Submit Key2GO Request.
2.
6
When the configuration is completed, reconnect the module.
The LED will turn ON solid green for 3 seconds and then turn OFF.
You have successfully completed the module programming sequence.