Installation Type 2
Not required in D2D mode.
Page 5
(-) Trunk Status Input
(-) Door Status Input
Remote
Starter
10
DBALL
Programming button
LED
1: Green: (-) Lock Input
2: Blue: (-) Unlock Input
3: Red/White: (-)
Trunk Release Input
9: Pink: (+) Ignition Input
8: Violet: (+) Starter Input
10: Blue/White: (-) GWR (Status) Input
4
TX
(-) Ground
RX
(+)12v
14
12
2
7: Brown
8: Yellow: R. Code (Car Side)
9: Orange/Yellow: R. Code (Key Side)
11: Yellow/Red: (+) 12v (Connector Side)
10: Orange/Red: (+) 12v (Car Side)
1: Light Green: Single Wire CAN
13: Red: (+) 12v
14: Black: (-) Ground
Driver Door
Sense Trigger
9: Violet/Brown
5: Violet/White: (AC) Tach Output
6: Gray: (+) Brake Status Output
1: Black/White: RAP OFF
3: Green/White: (-) Door Status Output
4: Red/Black: (-) Trunk Status Output
10: Yellow/Black: Keyless Data
8: Violet/Green: R. Code (Car Side)
P#: XKD2D65
(+) 12v
(-) Ground
You need to connect these
wires together. These
connections are required for
the module work properly.
BCM
C2
BCM is located in the center console.
Exception: in Pontiac Solstice and Saturn Sky: located under the carpet,
firewall.
passenger side
Connector C2
PIN 12
Connector C2
of the BCM
Connect these
wires only if the
vehicle is equipped
with PK3+.
(+) Brake Status Input
(AC) Tach Input
(+) Accessory Output
(+) Ignition Output
Red/White
Key Side
Black Connector located at the
ignition switch
(this connector
can have 5 or 6 pin).
BCM Side
1
2
3
4
5
6
(-) GWR (Status)
(+) Ignition Output
(-) Lock Output
(+) Starter Output
(-) Unlock Output
(-) Trunk Release Output
RF Loop Connector
Diagnostic connector
OBDII (connector side view)
1
8
16
9
R. Code
White, Pink
or Pink/black
Green or Black
connector located
at the ignition switch.
The position of the R. Code wire may vary.
Test this wire using the following chart:
- 12V at Key Input
- 4.3V at Ignition
- 0V at Accessory
- 3V at Start
(+) 12 V Input
Ground
Parking Lights
Hood Switch
Rev.: 20101103
Platform: DBALL
Firmware: GM5
Vehicle CAN Bus Integration System
© 2010 Directed Electronics. All rights reserved.
The Mobile Integration Systems