Installation Type 3
Page 6
Not required in D2D mode.
* Rear Hatch or Trunk Release Input
: With vehicle with motorized rear hatch, this input will release the hatch. See programming options to change its
operation.
Remote
Starter
(-) GWR (Status)
(+) Ignition 1 Output
(-) Lock Output
(+) Starter Output
(-) Unlock Output
(-) Rear Hatch or Trunk Release Output*
(-) AUX1 Right Sliding Door Output
(-) AUX2 Left Sliding Door Output
10
DBALL
Programming button
LED
1: Green: (-) Lock Input
2: Blue: (-) Unlock Input
3: Red/White: (-)
Rear Hatch or Trunk Release Input*
4: White/Violet: (-) AUX1 Right Sliding Door Input
5: Violet/Black: (-) AUX2 Left Sliding Door Input
9: Pink: (+) Ignition Input
8: Violet: (+) Starter Input
10: Blue/White: (-) GWR (Status) Input
4
TX
(-) Ground
RX
(+)12v
14
12
2
2: Purple/Yellow: J1850
13: Red: (+) 12v
14: Black: (-) Ground
Pin 37
P#: XKD2D65
(+) 12v
(-) Ground
(+) 12 V Input
Ground
Parking Lights
(+) Brake Input
Hood Switch
(+) Accessory Output
(+) Ignition 2 Output
31
1
10
41
40
49
52
21
11
44
Connector 1 at BCM
BCM is located at the left of steering column.
Exception: 2000-05 Pontiac Montana, 2000-05 Chevrolet Venture, and 2000-05 Oldsmobile Silhouette: located behind glove box.
If no wire is found in
pin 37, insert one to
enable connection.
10: Yellow/Black: Keyless Data
5: Violet/White: (AC) Tach Output
(AC) Tach Input
RF Loop Connector
Driver Door
Sense Trigger
1: Black/White: RAP OFF
Diagnostic connector
OBDII (connector side view)
1
8
16
9
(+) Starter
Rev.: 20101103
Platform: DBALL
Firmware: GM5
Vehicle CAN Bus Integration System
© 2010 Directed Electronics. All rights reserved.
The Mobile Integration Systems
