12
INSTALLING THE FUSELAGE SERVOS.
.
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the
servo into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Throttle servo.
Steering servo arm.
Rudder servo.
Retract servo.
Cut.
Elevator servo.
Install the spinner backplate, propeller
and spinner cone.
SPINNER INSTALLATION.
The propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
