R
e
a
r-
Fa
ci
n
g
I
n
st
a
llat
io
n
32
Infant Support Cushion: You may use the cushions up to any
weight for maximum comfort and support.
Rear-facing SuperLATCH™ Installation
(cont.)
Place car seat so that both
the seat bottom and feet of
the detachable base are flat
on the vehicle seat. Front of
car seat should be up
against back of vehicle seat.
Connect both SuperLATCH™
connectors to the correct
lower anchors in the vehicle
seating position. The red
button will “click” and pop
up to confirm secure
attachment to anchors. Red
buttons should be facing
upward for correct fit and easy
access. To release, press the red
button. Red button will stay
down when not in use.
Push down in the middle
where the child sits, while
tightening the SuperLATCH™
strap. To check for a tight fit,
grab the seat near the label
that states “rear-facing belt
path” with one hand and
give it a moderate tug. It
should move less than 1
inch side-to-side, back-to-
front.
Tip: If available, add the rear-facing top tether connector strap
to the appropriate anchorage and attach the top tether strap
(
See page 37 for installation instructions
).
Important: It may be necessary to move front vehicle seat
slightly forward to properly fit rear-facing car seat. The Diono
Angle Adjuster may be purchased separately to adjust recline, if
child can sit up unassisted and has full head control. Angle
Adjuster is not appropriate for a newborn.
❒
See final checklist on page 50
