Dion-Ag Scorpion 300, Operator'S Manual

Page: 27 / 109

SETUP
27
CAUTION: To prevent the rotation of the PTO shields, fastening chains (item 6 on Figure 17) are
provided and must be attached on both ends.
CAUTION: Attach a safety chain (Figure 18, item 7) with a minimum capacity of 9071 kg (20000 lbs)
for transport.
Figure 18 : Safety chain
DRAW BAR EXTENSION
IN THE CASE WHERE THE TRACTOR DRAWBAR IS TOO SHORT, (PAGE 50), PROCEED TO THE INSTALLATION OF THE
DRAWBAR EXTENSION.
FOLLOW THESE INSTRUCTIONS TO INSTALL A CAT. II DRAW BAR EXTENSION
Refer to
FIGURE 19
for the following steps:
STEP 1
Insert shims (items 1 and 2) inside extension (item3). Insert extension with shim inside the draw bar (item 4).
You need at least the thickness of one shim (item 2) to clear the bolt head.
STEP 2
Insert bolt (item 6) through the extension as shown below. Insert bolt (item 6) inside the plate (item 5).
Insert the spring (item 7) and nut (item 8) on bolt (item 6). Leave enough motion to lock the pin (item
STEP 3
Insert pin (item 9) with a spring pin (item 10) inside extension (item 3) and lock with plate (item 5). If the
hole in the draw bar is too large, insert a bushing (item 13) in the hole to reduce the clearance with the pin
(item 9)
STEP 4
Screw nuts (item 12) on bolts (item 11) and then screw bolts (item 11) on both sides of the extension
(item 3) as shown below.
Manual N o. F6918E003E v1.2