5 OF 7
IG050619-3.0
HYDROLUME
®
SLIM RGB LED STRIP LIGHT
INSTALLATION GUIDE
HYDROLUME
®
SLIM RGB LED Strip Light
INSTALLATION GUIDE
INSTALLATION (676) (CONT.)
2
DETERMINE LOCATION TO INSTALL COMPONENTS
AC IN
DC OUT
L
G
N
V
−
V+
+
−
1) Class 2 Driver
2) Control
3) Hydrolume
Refer to
SYSTEM DIAGRAMS
WIRE GAUGE & VOLTAGE DROP
Ensure applicable wire is installed between driver, fixture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rating, and type (in-wall rated, wet location rated, etc.)
3
ADHERE MOUNTING CHANNEL TO SURFACE
Once adhesive is dry, firmly press HYDROLUME into mounting
channel working one end to the other.
Either mount channel to dry surface using a chlorine resistant waterproof
adhesive, allowing adhesive to cure/dry. Or counter-sink screw into
channel groove.
ATTENTION:
FIBERGLASS & VINYL LINED POOLS
Unlike concrete pools, most fiberglass and vinyl lined pools have
strict warranty guidelines that do not allow the user to deface the
pool wall surface. Diode LED does not recommend mounting to
fiberglass or vinyl pool walls and/or defacing the surface in any way
(ex. drilling into surface to route lead wires). It is recommended
to mount to a separate pool coping or lip to ensure your pool
warranty is not voided. Always consult with your pool supplier and
contractor for proper installation of 3rd party products.
Wall Mount
Coping Mount
Concrete Pools Only
Concrete Pools
Fiberglass Pools
Vinyl-Line Pools
To Class 2 LED Driver,
GFCI, & Circuit Breaker
To Additonal
HYDROLUME
Pool / Spa
Junction Box
Corrosion
Resistant Conduit
4 in. Min.
48 in. Min.
J-Box to Edge of Pool
8 in. Min.
Bottom of J-box
to Top of Water Line
Seal Conduit Entry with
pool-grade silicone sealant
For concrete pools, seal conduit entry with pool-grade silicone
sealant.
DO NOT drill holes in fiberglass pools/hot tubs or vinyl-
lined pools
. An alternate method is to route the wire directly
out of pool.
3
CONT.
