Dinstar SBC3000, User Manual

Page: 14 / 71

2 Installation
SBC3000 Session Border Controller
Copyright©2011-2018 Dinstar
8
Installation Tools

Screwdriver

ESD wrist strap

Ethernet cables, power wires, telephone wires

Hub, telephone set, fax, and small PBX

Terminal (can be a PC which is equipped with hyperterminal software)
Unpacking
Open the packing container to check whether the SBC3000 device and all accessories have been in it:

One SBC3000 device

One 1.8-meter-long of power wire (AC 250V/4A)

Two network cables

One grounding cable

One serial console cable

Mounting ears and screws
2.2 Installtion of SBC3000
Put SBC3000 into Shelf
1. Put the SBC3000 device on the shelf or cabinet horizontally, or fix the mounting ears s of SBC3000 on the
cabinet by using screws (before that, you need to use screws to fix mounting ears on the left and the right of
SBC3000 repectively).
Connect Ground Cable to MTG3000
Connect one end of the ground cable to the grounding port on the back of SBC3000 and then connect the other
end to the grounding bar of the cabinet.