DINGLI JCPT2212DC, Operators Manual With Maintenance Information

Page: 37 / 71

OPERATOR
’S MANUAL
with Maintenance Information
Operating Instructions
32
Note: Slope rating is subject to ground
conditions and adequate traction.
Press the drive speed select button to the fast
drive speed mode.
To determine the slope grade
Measure the slope with a digital inclinometer
or use the following procedure.
You will need:
C
arpenter’s level
Straight piece of wood, at least 1 m long
tape measure
Lay the piece of wood on the slope
At the downhill end, lay the level on the top
edge of the piece of wood and lift the end until
the piece of wood is level.
While holding the piece of wood level,
measure the distance from the bottom of the
piece of wood to the ground.
Divide the tape measure distance (rise) by the
length of the piece of wood (run) and multiply
by 100.
Example:
Run = 3.6 m
Rise = 0.3 m
0.3 m ÷ 3.6 m = 0.083 x 100 = 8.3%
If the slope exceeds the maximum slope or
side slope rating, the machine must be
winched or transported up or down the slope.
See Transport and Lifting section.
Operation from Ground with
Controller
Maintain safe distances between operator,
machine and fixed objects.
Be aware of the direction the machine will
travel when using the controller.
Outrigger Operation
1 Position the machine below the desired
work area.
2 Push and hold the outrigger auto level
button.
3 Press and hold the function enable switch.
Activate the proportional control handle in
the direction indicated by the yellow arrow.
The outriggers will extend and level the
machine. A beep will sound when the
machine is level.
The indicator light on the lift function enable
button will turn on when one but not all
outriggers are down. All drive and lift functions
are disabled.
The indicator lights on the lift function enable
button and on the individual outrigger buttons
will turn off when all the outriggers are in firm
contact with the ground.
The drive function is disabled while the
outriggers are down.
To control individual outrigger
1 Push and hold one or more outrigger
function enable buttons.
2 Press and hold the function enable switch.
Activate the proportional control handle in
the direction indicated by the yellow arrow.
The outriggers will extend and level the
machine.
Emergency Lowering
1 Turn the key switch to ground control.
2 Press and hold the emergency lowering
down enable button.
3 Press and hold the emergency lowering
down button.