DINGLI JCPT0607DCS, Operator'S Manual

Page: 26 / 62

OPERATOR’S MANUAL
with Maintenance Information
Function Tests
21
drive position.
⊙
Result: The maximum achievable drive
speed with the platform raised should not
exceed 30.5cm/s.
¤
If the drive speed with the platform raised
exceeds 30.5 cm/s, immediately tag and
remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with
the platform controller. Do not stand in the
platform.
39 Fully lower the platform.
40 Place a 3×20 cm or similar piece of wood
under both wheels on one side and drive
the machine up onto them.
41 Raise the platform at least 1.3 m.
⊙ Result: The platform should stop and the tilt
alarm will sound at 150 beeps per minute.
42 Move the drive control handle in the
direction indicated by the blue up arrow,
then move the drive control handle in the
direction indicated by the white down
arrow.
⊙
Result: The drive function should not work
in either direction.
43 Lower the platform and drive the machine
off the block.
Test the Pothole Guards
Note: The pothole guards should automatically
deploy when the platform is raised. The
pothole guards activate another limit switch
which allows the machine to continue to
function. If the pothole guards do not deploy,
an alarm sounds and the machine will not
drive.
44 Raise the platform.
⊙
Result: When the platform is raised 1.3 m
from the ground, the pothole guards should
deploy.
45 Press on the pothole guards on one side,
and then the other.
⊙
Result: The pothole guards should not
move.
46 Lower the platform.
⊙
Result: The pothole guards should return to
the stowed position.
47 Place a 3×20 cm or similar piece of wood
under a pothole guard. Raise the platform.
⊙ Result: Before the platform is raised 2 m
from the ground, an alarm should sound
and the drive function should not Work.
48 Lower the platform and remove the 2×20
cm wood block.