OPERATOR’S MANUAL
with Maintenance Information
Safety Rules
4
original equipment. Batteries are used as
counterweight and are critical to machine
stability. Each battery must weigh 17.6 kg. The
batteries must weigh a minimum of 35.2 kg.
Do not modify or alter an aerial work platform
without prior written permission from the
manufacturer. Mounting attachments for
holding tools or other materials onto the
platform, toe boards or guard rail system can
increase the weight in the platform and the
surface area of the platform or the load.
Do not place ladders or scaffolds in the
platform or against any part of this machine.
Do not transport tools and materials unless
they are evenly distributed and can be safely
handled by person in the platform.
Do not use the machine on a moving or mobile
surface or vehicle.
Be sure all tires are in good condition and lug
nuts are properly tightened.
Crushing Hazard
Keep hands and limbs out of scissors.
Maintain a firm grasp on the platform rail when
removing the rail pins. Do not allow the
platform guard rails to fall.
Operation on Slopes Hazard
Do not drive the machine on a slope that
exceeds the slope and side slope rating of the
machine.
Slope rating applies to machines in the stowed
position.
Fall Hazard
The guard rail system provides fall protection.
During operation, occupants in the platform
must wear a full body harness with a lanyard
attached to an authorized lanyard anchorage
point. Attach only one (1) lanyard per lanyard
anchorage point.
Do not sit, stand or climb on the platform guard
rails. Maintain a firm footing on the platform
floor at all times.
Do not climb down from the platform when
raised.
Keep the platform floor clear of debris.
Close the entry gate before operating.
Do not operate the machine the entry gate is
secured for operation.
Collision Hazard
Be aware of limited sight distance and blind
spots when driving or operating.
Operators must comply with employer, job site
Model
Maximum
slope rating
Maximum
side slope rating
and governmental rules regarding use of
personal protective equipment.
stowed position stowed position
JCPT0307
25% (14°)
25% (14°)
JCPT0407
25% (14°)
25% (14°)
Check the work area for overhead obstructions
or other possible hazards.
Note: Slope rating is subject to ground
conditions and adequate traction.
