Dimplex WI 14CS, Operating Manual

Page: 3 / 32

3
1.2 Legal Provisions and Directives
This heat pump is in compliance with all relevant
DIN/VDE regulations and EU directives. These
are described in more detail in the EC Declaration
of Conformity.
The electrical connection of the heat pump must
be performed according to and conforming with
all relevant VDE, EN and IEC standards. Beyond
that, all connection requirements of the local
electrical utility company have to be observed.
The heat pump is to be plumbed into the heat
source and heating systems in accordance with
all relevant regulations.
1.3 Energy-Efficient Use of the Heat
Pump
By operating this heat pump, you contribute to the
protection of the environment. An important
prerequisite for energy-efficient operation is the
careful sizing of the heating system and the heat
source. In particular, it is important to keep water
flow temperatures as low as possible. All energy
consumers connected should therefore be suitable
for low flow temperatures. A 1 K higher heating water
temperature corresponds to an increase in power
consumption of approx. 2.5 %. Underfloor heating
systems with flow temperatures between 30
°
C and
40 ° C are optimally suited for energy-efficient
operation.
READ IMMEDIATELY
1
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
READ IMMEDIATELY
1.1 Important Information
The well water must meet the required
water quality standards.
The heat pump is not attached to the
wooden pallet.
The heat pump must not be tilted
more than max. 45
°
(in either direction).
Do not lift unit by the holes in the panel
assemblies!
Flush the heating system prior to
connecting the heat pump.
When connecting the load lines be
sure to observe the clockwise phase sequence.
Commissioning of the heat pump
must be performed in accordance with the
operating instructions of the heat pump
controller.
Any work on the heat pump may be
performed by an authorised and competent
customer service only.
Before opening the unit, all electrical
circuits must be disconnected from the power
supply.
CAUTION!