EN-8
2202/D
www.dimplex.eu
English
Scope of supply
4. Scope of supply
Casing with accessory package and storage stones
are packaged and delivered separately.
The accessory package includes the following parts:
screws, dowel, washer for tilt protection.
Fixing screws for wall connector blocks.
The wall connector blocks are on the polystyrene
trays.
Please check that everything has been supplied cor
-
rectly. Please follow the instructions in the informa
-
tion sheet if you would like to report transport dam
-
age.
NOTE
i
Do not carry the device by the packaging straps. This
could cause them to tear.
NOTE
i
The device should always be carried by two people.
NOTE
i
Minor damage on the storage stones has no impact
on the operation of the device.
5. Installation location
Please check that the foundation is adequately stable
for the weight of the device. The foundation you store
the device on must be smooth and level.
The device can be installed on any normal flooring. In
the case of vinyl or parquet flooring, or floors with light
carpets, the colour of the floor may be impaired
around the feet due to the effects of pressure or heat.
Sections of wall covering or carpet that come into
contact with the rear of the device must be removed.
Supporting boards (special accessories) must be used
if:
heat-sensitive floor coverings are present which
can not reliably withstand temperatures over
80 °C.
the feet could sink into the ground, preventing air
exchange underneath the storage heater.
All values given in mm.
The best place to install the storage heater is under a
window.
If 2 storage heaters are installed next to each other, a
minimum clearance of 20 cm must be observed. Any
objects must be at a distance of at least 30 cm from
the air outlet grid. This is also true for deep-pile car
-
pets.
47 mm
216 mm
268 mm
320 mm
664 mm
VFE 20 VFE 30
626
776
VFE 40
926
VFE 50
1076
VFE 60
1226
VFE 70
1376
A
A
100
100
300
100
