•
While the product is in operation, the cable must be fully uncoiled. The cable should be
positioned towards the bottom of the cable wrap box so the door can be closed.
•
The cable can be positioned to exit the product from the left or right hand side.
WARNING
The supply cord must be fully uncoiled before use.
Operation
Before using the heater ensure that all warnings and instructions have been read carefully.
IMPORTANT:
OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER.
IMPORTANT:
DO NOT OPERATE WITHOUT CASTORS FITTED.
When the appliance is plugged in the Neon indicator will illuminate to indicate that the unit is
powered up and ready for use. Use the heat selection knob to select the desired heat output. The
thermostat dial can be used to set the desired room temperature, this will automatically regulate
the appliance output to maintain a steady room temperature.
Note: On initial power up please ensure the thermostat dial is set to the Max position. If the
thermostat is set lower than the current room temperature the appliance will not energise.
IMPORTANT:
The element has been coated with a protective film which will burn off during the first few minutes
of use and may cause a small amount of fuming. This is quite normal – the fumes are non-toxic and will quickly
disappear. We recommend that you open a window to ventilate the room when using the heater for the first time.
Positioning the Heater
WARNING:
Always ensure the information outlined in IMPORTANT SAFETY INFORMATION section is strictly
adhered to.
Always ensure that the heater is stood on a firm, level base near to, but not directly underneath a suitable mains
supply socket.
Select the position for the heater ensuring there is clearance from any furniture and fittings of at least 300mm
above the heater and 150mm each side and 300mm from the control and end panel. We recommend maximising
the clearance where possible.
Controls
Off/ Heat Selection dial
Neon Indicator
Thermostat dial
24 Hour Timer
