Dimplex FD 9305, Operating Instructions Manual

Page: 37 / 74

452114.66.71 FD 9305 EN-13
L14< Wärmepumpenmanager
Englis
h
NOTE
Heating request
A heating request is present if the "Return set temperature" minus the
"Hysteresis return set temperature" is higher than the current measured
"Return temperature".



Display of outside air and supply air temperature



Display of exhaust air and extract air temperature



Display speed supply air fan



Display speed exhaust air fan


Displays the temperature measured by the frost protection sensor cooling.

Displays the temperature measured by the hot gas sensor (R18)





Indicates whether a request for domestic hot water has been made. Even if a request
is pending, it is possible that the heat pump still does not operate (e.g. programmed
shut-off times, operating limits, heating up). This block is shown by the preceding lock
symbol

.
Displays the current domestic hot water set temperature.
Displays the measured hot water temperature (R3).

Display of the current maximum domestic hot water temperature for the 1 compressor
operation

Display of the current maximum domestic hot water temperature for the 2 compressor
operation




Indicates whether a request for swimming pool water is pending. Even if a request is
pending, it is possible that the heat pump still does not operate (e.g. programmed
shut-off times, operating limits, heating up). This block is shown by the preceding lock
symbol

.
Displays the current swimming pool set temperature.
Displays the current swimming pool temperature (R20).



Displays the heat source temperature (R27).
Displays the temperature measured at the outlet of the heat source (R6).



Displays the current pressure (R26) on the high pressure side.
Displays the current pressure (R25) on the low pressure side.

Displays the heat source temperature (R24) for systems with a combination of
passive cooling and a reversible heat pump.

Displays the heat pump type identified from the coding resistor (R7).


Displays the heating controller software version including the boot and bios version,
as well as the valid network address.

Displays which extension modules are available.

Display of sensor and system values