5
MAINTENANCE
WARNINg:
If the fireplace was operating prior to
servicing allow at least 10 minutes for light bulbs and
heating elements to cool off to avoid accidental burning
of skin.
WARNINg:
Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
Light Bulb Replacement
Light bulbs need to be replaced when you notice a dark
section of the flame. There are two bulbs under the log set
which generate the flames and embers. It is a good idea to
replace all of the light bulbs at one time if they are close to
the end of their rated life. Group replacement will reduce
the number of times you need to open the unit to replace
the light bulbs.
Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs with
an E-12 (small) socket base, 60 Watt rating. Example: GE
60BC or Philips 60CTC.
CAUTION DO NOT EXCEED 60 WATTS PER BULB
Required tools:
Phillips screw driver
To replace the light bulbs in unit with Front Face
Controls:
Unplug the unit from the outlet.
1.
Unsnap the front door from the unit.
2.
Remove the lower moulding from the unit.
3.
Lift up, and remove the unit from the wall. Set the unit
4.
down on it’s right side.
Remove the rear door from the left side of the unit by
5.
unfastening the Phillips screw. Set the door and screw
aside. (Figure 5)
Reach inside opening to remove the bulb(s). Remove
6.
the nearest bulb before attempting to remove the fur-
ther bulb. Bulbs are unscrewed in counter-clockwise
direction.
Insert new bulb(s).
7.
Assemble in reverse order and re-hang on the wall.
8.
Plug in the corner wall mounted electric fireplace.
9.
To replace the light bulbs with controls beside
log:
Unplug the unit from the outlet.
1.
Open latched door.
2.
Remove the three (3) mounting bracket screws and set
3.
aside mounting bracket. (Figure 6)
Remove the two (2) log set screws and remove the log
4.
set.
!
IMPORTANT:
Only handle the Log Set by the Ember
Bed.
Unscrew the bulb(s) counter clockwise.
5.
Insert new bulb(s) screwing clockwise.
6.
Mounting
Bracket
Log Set
Figure 5
Assemble in the reverse order as above.
7.
!
NOTE:
When placing log set back into unit ensure the
log set sits in between the 2 vertical mounting flanges.
gLASS CLEANINg
The glass is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc., the
clear door may collect dust particles; these can be removed
by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the clear door can
be cleaned with a damp cloth. The clear door should be
completely dried with a lint free cloth to prevent water
spots.
CAUTION:
Do not use abrasive cleaners on glass
surface or spray liquids directly onto any surface.
FIREPLACE SURFACE CLEANINg
Use a cloth dampened with warm water only to clean
painted surfaces of the electric fireplace. Do not use
abrasive cleaners.
Figure 6
Rear
Door