8
www.dimplex.com
Maintenance and Cleaning
WARNING:
Disconnect power be-
fore attempting any maintenance
or cleaning to reduce the risk of
fire, electric shock or damage to
persons.
!
NOTE:
This heater should not
be operated with an accumulation of
dust or dirt on or in the unit, as this
can cause a build up of heat and
eventual damage. For this reason the
heater must be inspected regularly,
depending upon conditions and at
least at yearly intervals.
Allow at least 30 minutes for the
heater to cool before attempting any
maintenance or cleaning. To clean
the exterior surface, use a solution of
water and mild detergent, apply with
damp sponge. Wipe dry with a dry
cloth.
DO NOT
re-energize unit until
it has dried thoroughly.
Operation
WARNING:
This heater must be
properly installed before it is used.
Setting the Thermostat
1. Before connecting or discon-
necting the power, turn unit off
by turning knob fully
counter
clockwise
. (See FIGURE 4)
2. Heater is equipped with a ther-
mostat. To adjust temperature to
your individual requirements, turn
thermostat control knob
clock-
wise
all the way to turn heater
on. When room reaches desired
temperature, turn thermostat
knob
counter clockwise
until
you hear a click. Leave in this po-
LOW
HI
Figure 4: Thermostat Control
Knob
sition to maintain room tempera-
ture at this setting. For additional
heat, turn
clockwise
until you
hear a click again and heater will
turn on. To turn heater to lowest
setting, turn thermostat knob
counter clockwise
all the way.
