16
Add extra remote control (remote control learning):
Remove the gate opener cover,
then take out the upper cover of the control box, press and hold the learning button K4
on the control board for 2 seconds, the indicator light LRN will be on; press the button
that to be learned on the remote control twice, the LRN will flash several times and be
off; remote control learning complete. A maximum of 25 remote controls can be
learned.
Delete remote control:
To delete remote control that have been learned; press and
hold the learning button K4, the indicator light LRN will be on; then release it until LRN
is off. After the steps, all the matched remote controls will be deleted.
The fourth button on the remote control is for pedestrian mode, press the button while
the door is closed, it will open for 1 meter which is for pedestrian only.
Note 1:
To disengage gate opener, move the gate to the middle position, then close
the clutch and press the open button of external button switch to open the gate. If the
gate opening direction is wrong, adjust the dip switch 5 to change left and right
installation position (re-powered) or exchange the motor lines red and black to change
motor direction. Please seriously observe whether the motor can stop automatically
when the gate is fully opened. If the position cannot be limited correctly, please
exchange limit switch lines CL and OP.
Note 2:
After installed or Re-power up, please drive one opening and closing cycle by
pressing remote control button or external button, then the door width will be
remembered by control unit and the "soft start slow stop" function will be enabled in
next working cycle.
3.3.9 Other connections
3.3.9.1 Battery connection
