❖Code
Position:
Left
Direction: L to R
Position:
Right
Direction: L to R
Position:
Left
Direction: R to L
Position:
Right
Direction: R to L
Emergency stop switch ON
Emergency stop switch OFF
Input stop signal release
Turn on Reset switch
Input stop signal
Automatic reset after clear
EnD
Work shortage sensor ON
EnD_2
EnD
EnD_2
Interfere releasing
Turn on "Reset" switch
Input feed signal during feeding
Input feed signal during releasing
Input release signal during feeding
O_run
Overrun
❖Caution display
This caution displays have a possibility which the feeder is reset. These displays are as the follows,
Reset : Blinking. Feed Angle SPM :
C.
Number
Code
C.
40
Open phase
Confirmation of the power supply
C.
41
Low voltage detection
Checking the voltage
C.
50 -1
C.
50 -2
Number
State / Content
Note
Motor connection anomaly
Contact failure
I - F
7.7.7.7.7.7.
666666
101010
Input stop signal during driving
press
1.0.1.0.1.0.
662662
663663
777777
1.1.1.1.1.1.
Another work shortage sensor ON
Work shortage sensor release
Another work shortage sensor release
Turn on "Sync Feed" and "Sync
Release" after turn on "Reset"
switch
664664
661661
After releasing the Emergency
stop switch, turn off the power
Turn on Reset switch after input
stop signal release
4.4.4.4.4.4.
444444
After setting a work pieces, turn
on "Reset" switch
Turning off "Sync Feed", the work
shortage sensor will disabled.
The code will display the operating state of the feeder to suit the operation state and setting
disabled state.
ENG
STOP
Contents
Method of reset
Model
number
When turning on power only, the
control panel displays the program
Feed Angle SPM
- - ] ]
-. -..].].
CC - -
C. C. -. -.
Feed Length
r30
6
CS-0173_1
