❖Adjusting Press cam signals
Feed signal adjusting
Set the feed start position to feed signal OFF position.
Press cam signal
When you make the feed starts on 270°,
0°
Set the ON angle of feed to 240°, and set the OFF angle to 270°
270°
90°
ON
240°
Release signal adjusting
180°
0°
When the release angle is assumed to 200°from 200°,
60°
you turn on the press cam signal in 110 degrees,
and turn off in 200 degrees.
270°
90°
110°
200°
180°
❖Release setting in the controller 【 （＿Release Mode） 】
【 （＿Release Mode） 】 the display is the back screen of 【 Feed Length 】.
Release Mode is not displayed in "Set" state only.
To display " Release Mode", Push on "Sync Release" switch in "Set" state.
To change the "Release Mode", Keep "Sync Release" switch ON, and using "+" or "-" switch,
You can change the release mode.
Display and contents
Invalid the release signal, Release off state.
Release angles setting. It can be input from 1°to 50°.
Input the release start using the press cam signal.
Release timer setting. It can be input from 0.001sec to 0.05 sec.
Input time period, the release carry out.
Input the release start using the press cam signal.
The delay time will vary depending in the springs pressure.
Set the ON to the release start angle, and set
the OFF to the finish.
NOTE
Need to set the ON of the feed signal to the
feed completed angles when using option
"Overrun-Function".
_ _ _ A50
Need to adjust the signal of the release
start even if the release system is used a
time setting of timer or angles.
The retention angles of the release ON must
be 25 degrees or more.
Feed Length （＿Release Mode ）
Contents
_ _ Sync
Synchronization press cam signal
_ _ _ OFF
_ _ _ A01
～
the control calculates the release time from the setting SPM and the
angles, the release will operate in the time range.
～
_ _ _ T50
NOTE
The release operation is delayed due to air cylinder.
_ _ _ T01
5
