Dik Geurts Ivar 10 H2O, Store, Instructions For Installation Manual

Page: 40 / 96

40
English
IN ST AL LA TI ON MAN UA L
9.5.1.2 Assembly/disassembly of glass panes in door
!Caution
• Avoid damage when removing/fitting the glass pane.
• Avoid/remove fingerprints on the glass pane(s) as they will burn into the glass.
!Tip
Use the supplied glass pane cleaner to remove fingerprints from the glass pane(s).
To remove the glass pane and then remount it in the door, please observe the instructions below (see appendix 2,
fig. 9).
!Caution
It is important that both glass panes and the glass pane frame are mounted in the same sequence and with the
same orientation as when they were removed. The inner glass pane has an IR Coating, which must be placed on
the inside of the appliance.
Disassembly of glass panes in door:
Ø
Open the door.
Ø
Lift out the door by sliding it upwards.
Ø
Place the door on a flat surface.
Ø
Unscrew the 6 bolts that hold the glass strips.
Ø
Lift out the glass panes and the intermediate frame.
Assembly of glass panes in door:
Ø
Mount the glass pane and place back the door by performing the steps for disassembling the glass pane in
reverse order.
!Caution
• Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.
• Place the glass pane (including new pane seal) with the logo to the bottom right.
9.5.1.3 Replacing door seal
For replacing the door seal, proceed as follows (see appendix 2, figure 10):
Ø
Remove the door seal by taking it out of the integrated groove.
Ø
Remove excess kit residues from the door seal groove.
Ø
Use a heat-resistant kit to apply a new layer of kit in the groove.
Ø
Place the new door seal.
!Caution
Regularly check the sealing of an RS appliance, replace if necessary to guarantee RS.
EN