Chapter 2: Card Installation
installed any of these, Digium recommends that you upgrade to the latest
version of each.
1.
After the machine has booted to Linux, log in and execute the
following command to list the devices detected by the PCI bus.
# lspci -d d161:*
2.
Confirm that the output lists a device with Digium’s PCI vendor ID
which is “d161”. The PCI device ID shown immediately after “d161:”
will be populated with one of the identifiers listed in the table below.
Table 1: Card Identifiers
Model
Identifier
TE131/TE133
800A
TE132/TE134
800B
A Digium TE130 Series card identifier should be listed. If a matching
card identifier is not listed, then your machine is not PCI 2.2 (or
higher) or PCI Express compatible, and the card will not work with
your motherboard.
For further verification, the screen output from
lspci
should be similar
to the following:
Digium, Inc.
Page 30