13
6. Driver Installation
You can use any DA-80200 accessories data cable without installing driver
except USB cable. The following is the steps of installation USB cable.
6.1 System
Requirement
CPU: IBM, Pentium, or other compatible PC.
Memory: above 16 MB
System: Windows 98/Me/2000/XP
6.2 Installation
I. Copy entire DA-80200 USB folder from CD to hard disk.
II. Connect USB connector to computer without DA-80200 GPS receiver. While the
computer automatically starts the installation program, please direct the driver
to the DA-80200 USB folder.
6.3 Important
Verify the COM port to start using your own navigation software.
I. Click
<Start>
menu, select
→
<Setting>
, then enter
→
<Controller>
II. After
entering
<Controller>
, and select
<System>
.
III. Select
<Device Manager>
.
IV. Find the
< Connector
(COM & LPT)
>
and check the Virtual COM Port, which
was created by the USB driver.
Please note that the virtual COM port number might be different from every
computer. Before using navigation software, please confirm the COM Port numbers
created by your computer and provided by your navigation software. Otherwise, the
navigating software won’t receive the satellite signal, because of the un-match
COM Port setting.
7. Trouble Shooting
Problems Reasons
Methods
No position
output but
timer is
counting
Weak or no GPS signal can be
received at the place of DA-80200
Connect an external antenna, which
locate as a open space to your
DA-80200
and then run GPSViewer Cold
start function.
Summary of Contents for DA-80200
Page 1: ...User s Guide DA 80200 ...
