© 2022 Digitrax, Inc.
www.digitrax.com
— 5 —
4.0 SE74 Options: OPSW changes
The SE74 configuration and be
-
havior can be configured using non-volatile OPSW's. The Factory default OPSW
settings will configure most common requirements.
1.
Press and hold the OPS button for about 3 seconds until the green ID and
RTS LEDs blink alternately. Release the OPS button. The SE74 is now setup
to configure OPSW 1 to 48 by sending the required SW# as C or T to setup
an option.
2. Send a SW# in range 1-48 as C/T matching the valid settings from Table 1
OPSW settings shown below.
3. When finished press and hold OPS button for 3 seconds to exit OPSW setup
mode. The SE74 will now restart with the new OPSW settings.
4. Factory default OPSW settings are shown in
BOLD
.
5. OPSW's not in this table are reserved and should be kept at Factory default T
settings for predictable operation.
6. OPSW40 =C will reset to Factory defaults on OPSW mode exit
Table 1: SE74 OPSW setting table
:
OPSW# Default=
bold
Action:
1
T
C = Slow motion turnouts, T = pulse/solenoids
5
T
C =DCC Aspect control mode, T = SW control
6
T
C =Disable internal Routes
10
T
C = Bushby bit active
11
T
C = 8 input lines trigger Routes
14
T
C = DCC SW commands only
15
T
C = Do not echo Route SW's to Loconet
16
T
C = Solenoid pulse hi CD voltage
30
T
C = Send B2 not B0 input SW messages
33
T
C = 2-wire searchlight signals (figures 8/9)
34
T
C = Searchlight, T = 3 color signals
35
T
C = Common cathode signals, T=common anode
37,36
T, T
C, T
T, C
C, C
Flashing Yellow, 4th SW aspect
Flashing Red, 4th SW aspect
Dark, 4th SW aspect
Flashing Green, 4th SW aspect
38
T
C = Disable SW1021/1022 signal broadcast
40
T
C = Set Factory defaults
41
T
C = Make Lunar aspects Persistent