DigiTech Mistral3, User Manual

Page: 19 / 30

Loop mode ( L x )
This operating mode is similar to the Timer mode, with the difference that if
you use the external remote control or press the key, in
addition to displaying the error vs. the 0, the countdown will restart and
automatically reset the programmed duration.
After setting the duration as described above, if you exit the programming
mode the will default to “ready to start” and display the
programmed duration and the lap counter (bottom right of the display) as 0.
Operate the remote control to start the Countdown.
When you pass the finish line and operate the remote control, the display
“freezes” the lap time ( SPLIT ), while counting restarts from the value of the
programmed duration. The lap counter is increased by one unit.
Counting is automatically resumed after the pre-programmed time or by
pressing the key.
I
WARNING: if you have set the value of freezing seconds after
the SPLIT =no , in this mode the lap time will be displayed for 2
seconds and then it will automatically go back to the next count.
Also in this case you can change in any moment the value of the duration of
the countdown and obtain the same effects described in the Timer mode.
In order to return to the “ready to start” mode, hold the
key pressed
for 2 seconds.
english The countdowns
15