Edit the Preset
The next step to creating our example Preset is to enter the Preset Edit mode.To do this, press the Effect Select
Down button once. At this point the Matrix LED in the Wah-Pickup row should light.The Display will briefly show
EDIT
and then cycle between showing the status of the Wah and Pickup simulator Effects. If the Display shows that the
Wah is on (
WAH ON
), press the Status button once to turn it off (since our example is not using a Wah).
Select the Pickup Type
In our example Preset we were assuming that we were using a single coil pickup, but wanted it to sound like a double
coil humbucker.With the Wah-Pickup LED lit, rotate the Number 4 Knob until the Display shows
SC>HB
.This means
that a single coil will sound like a Humbucker.
Turn the Compressor Off
Next, we didn’t want to use compression in our Preset so, we need to turn the compressor off. Press the Effect
Select Down button again.The LED on the Compression row will light and the Display will show the current status of
the Compressor. If the Compressor is on, press the Status button until the Display shows
CMPOFF
.The Compressor
will then be disengaged.
Turn the Whammy™/IPS Off
We didn’t want to use any Whammy™ or IPS effects in this Preset. Press the Effect Select Down button again and
the LED on the Whammy/IPS row will light. If the Display indicates that either one of these effects is active, press the
Status button until the Display reads
IPSOFF
(IPS Off).
28
S
ECTION
F
OUR
- T
UTORIAL
