For product support please see www.digitalyacht.co.uk
Page 24
AIT2000 Installation & Operation Manual
VERSION 1.01
It is recommended that all Baud Rates and GPS Output Sentences are not changed from these defaults, which
have been chosen for maximum compatibility with the most common installations.
Once this data is entered, please double check all of the values, paying particular attention to the MMSI number
as once set this cannot be changed without the unit being returned to Digital Yacht.
Once you have checked that the data is correct, click the “Write Configuration” button and you will see the final
warning window shown in Figure 10.
If you are 100% sure that everything is correct, click the “Programme” button and your AIT2000 will now be pro-
grammed/configured with the data you have entered.
If your AIT2000 is installed and fully powered up from the boat’s 12v or 24v supply, then the AIT2000’s GPS will
now start to operate. Click on the “GPS Status” tab to see what the satellite signal strengths are like – you need a
minimum of 3-4 satellites with >20 signal strength to get a position fix.
Figure 10
