For product support please see www.digitalyacht.co.uk
Page 15
AIT2000 Installation & Operation Manual
VERSION 1.01
5
INSTALLATION PROCEDURES
It is strongly recommended that you read all of the instructions in this manual prior to installation.
If after reading this manual you are unsure about any element of the installation process please contact your
dealer for advice.
The following sections explain the installation process step by step for each of the main elements of the system.
5.1
Installing the AIS transponder
Please note the following guidelines when selecting a location for your AIS transponder:
The AIS transponder must be fitted in a location where it is at least 0.5m from a compass or any magnetic
device.
There should be adequate space around the AIS transponder for routing of cables. See drawing below for
details of the AIS transponder dimensions.
The ambient temperature around the AIS transponder should be maintained between -25°C and +55°C.
The AIS transponder should not be located in a flammable or hazardous atmosphere such as in an engine
room or near to fuel tanks.
The AIS transponder is fully waterproof to ingress protection rating IPx5, however it is recommended that
the AIS transponder is not subjected to extended periods of exposure to spray or submersion.
It is recommended that the AIS transponder is installed in a 'below decks' environment.
It is acceptable to mount the AIS transponder either vertically or horizontally.
Remove the green décor strips to expose 4 mounting holes to screw the unit to a suitable bulkhead or
surface.
The AIS transponder should be mounted in a location where the indicators are readily visible as these
provide important information on the status of the AIS transponder.
