Installation -
Metal Plate Installation
9
Template Sheet
2
3
4
5
6
7
8
1.
Using the mounting template sheet for the
metal plate, or the metal plate itself, mark and
drill the necessary holes in the wall or ceiling.
2. Pass the wires through the mount bracket and
make all necessary connections. See page 12
for more information.
3. To use the camera’s waterproof wiring:
a. Install the LAN cable into (a) .
b. (b) will be assembled to (a) with a 1/4 turn.
c. Thread (c) tightly to (b).
NOTE: to ensure a proper moisture seal,
make sure the o-ring is in place between (a)
and (b). In extreme environments, use an
outdoor-rated sealer.
NOTE: When using the waterproof cap,
crimp the RJ-45 connected after passing the
camera through the waterproof cap.
4.
Remove the rubber stopper and mount the
camera base to the mounting surface using
the included mounting screws.
5.
Adjust the camera module's position by using
its 3-axis gimbal. The camera ca
n
:
•
Rotate: 360°
•
Pan: 360°
•
Tilt: 70°
6.
Assemble the cover over the camera body. Be
sure to assemble the cover and bottom case
to match the case outline.
7.
When the installation is completed, remove
the protective film.
a
b
c
