[W
SYSTEM SETUP
OSD -
3
5
6
SET HOME POSITION
Home position means the origin of pan angle calculation.
The value of the pan angle displayed on the screen is based on
this home position.
By using the joystick, move the camera to the desired position
and press Near key.
Home position does not effect the tilt angle.
If you change the location of the home position, all horizontal
locations of your set functions such as preset, scan, pattern,
group, and privacy zones mask will be shifted based on the
new home position.
If there are no saved locations for the preset, pattern, scan,
and/or group, the camera will automatically move to the home
position after rebotting.
If power up action is set as ON, camera will continue the last
function that was executed right before reboot.
Set Home Position?
When the camera block is replaced or the orientation of the camera
is changed due to maintenance operations, it is very difficult to
maintain the same pan orientation. All the data for the functions that
depend on pan orientation, such as preset, scan, pattern, group, and
privacy zone mask, are no longer useful. However, even in this case,
you can reuse the data if you redefine the set home position to the
previous home position.
SET NORTH DIRECTION
By using the joystick, move the camera to the desired northern
position and press Near or Enter key. The direction will be
displayed on the screen.
Direction will be displayed as one of the following:
N (North)
S (South)
E (East)
W (West)
NE (Northeast)
NW (Northwest)
SE (Southeast)
SW (Southwest)
5
6
[NEAR:SELECT/FAR:CANCEL]
0/0/x1/N
SET HOME POSOTION
- - - - - - - - - - - - - - - - - - - - - - - - - - -
MOVE TO TARGET POSITION
[NEAR:SELECT/FAR:CANCEL]
0/0/x1/E
SET NORTH DIRECTION
- - - - - - - - - - - - - - - - - - - - - - - - - - -
MOVE TO TARGET POSITION
[NEAR:SELECT/FAR:CANCEL]
0/0/x1/N