Digital Watchdog DWC-MTT4Wi36, User Manual

Page: 24 / 63

6 .3 PTZ Configuration
This function is only available for the models with RS485 interface. It can be used with
a compatible external PTZ enclosure. Go to PTZ
→
Protocol interface as shown below.
Set the protocol, address and baud rate according to the PTZ.
6 .4 Alarm Configuration
6 .4.1 Motion Detection
Go to Alarm
→
Motion Detection to set motion detection alarm.
1. Check “Enable Alarm” check box to activate motion based alarms. If unchecked,
the camera will not send out any signals to trigger motion-based recording to the
NVR or CMS, even if there is motion in the video.
Alarm Out: If selected, this would trigger an external relay output that is connected to
the camera on detecting a motion based alarm.
Trigger Snap: If selected, the system will capture images on motion detection and
save the images on an SD card (this function is only available for the models with SD
slot).
Trigger SD Recording: If selected, video will be recorded on an SD card on motion
2 4