Specifications subject to change without notice
© Digital View Ltd – Doc Ver 1.01 : 15 Dec, 2017 (hsp-1920-manual-v101.doc)
Page
6 of 47
CONNECTION & OPERATION
CAUTION
: Never connect or disconnect parts of the display system when the system is powered up as this may cause serious
damage.
CONNECTION
Connection and usage is quite straight forward (it is useful to have the relevant connection diagram available at this time):
1.
LCD panel & Inverter:
Connect the inverter (if it is not built-in the panel) to the CCFT lead connector of the LCD panel.
LVDS type panel
s
:
The controller board has the built-in LVDS transmitter driver. Plug the LVDS cable to J3. Insert the
panel end of the cable the LCD panel connector.
2.
Inverter & Controller:
Plug the inverter cable to CNB1 and CNA1 (if necessary). Plug another end to the connector on
the inverter.
3.
Function switch & Controller:
Plug the OSD switch mount cable to CNC1 on the controller board and another to the
OSD switch mount.
4.
LED & Controller:
Plug in a 3-way with dual colour LED to connector LED1 on the controller board.
5.
IR & Controller:
Plug in a 3-way with IR sensor to connector IR1 on the controller board.
6.
Jumpers & Switches:
Check all jumpers and switches (SW3, SW4) are set correctly. Details referring the connection
diagram (a separate document) or the jumpers and switches setting table (in the following section).
7.
Jumpers & Inverter & Panel voltage:
Particularly pay attention to the settings of JA3, JA5, JA6, JB2 and JB3. JB2 &
JB3 are used for inverter control (read inverter specification and information on the jumper table to define the correct
settings). JA3 & JA5 & JA6 is used for panel voltage input (read panel specification and information on the jumper table
to define the correct settings).
8.
Input signal cable & Controller:
Plug the corresponding signal input to the connector on the controller board.
9.
Power supply & Controller:
Plug the DC 12V/24V power in to the connector PP5 or PP2. You can consider to use
DigitalView mating power cable P/N 426013800-3, 160mm for PP5 connection.
11.
External panel power input :
Plug power cable : P/N 426013700-3 for external panel power input (3.3 (max 7A) / 5V
(max 7A) / 12V (max 5A) / 18V (max3.5))
12.
Power on:
Switch on the controller board and panel by using the OSD switch mount.
LED status (LED1 / LED1A) :
Backlight status
LED color
Backlight OFF
RED
Backlight ON
GREEN
LED status (LED5A1) :
LED color
Controller power ON
Green
LED status (LED6) :
Panel power output status
LED color
10V / 12V / 18V panel power output
GREEN
3.3V / 5V panel power output
RED
General:
•
If you are using supplied cables & accessories, ensure they are correct for the model of panel and controller.
•
If you are making your own cables & connectors refer carefully to both the panel & inverter specifications and the section
in this manual, “Connectors, Pinouts & Jumpers” to ensure the correct pin to pin wiring.
PC SETTINGS
The controller has been designed to take a very wide range of input signals however to optimize the PC’s graphics
performance we recommend choosing 60Hz vertical refresh rate – this will not cause screen flicker.
OPERATION
Once the system has been connected and switched on there are a number of functions available to adjust the display
image as summarized in the following sections. The settings chosen will be saved for each mode independently.
