Specifications subject to change without notice
© Digital View Ltd – Doc Ver 1.00 : 13 Jan, 2021 (SP-1920-DUAL-HDMI_manual.doc)
Page
37 of 42
Appendix V – Media Failover Function
SP-1920-DUAL-HDMI has a capability to play media file via USB that this feature called 'Media failover' option. It
means when the video input source is no signal / loss of sync on a designated input, the built-in media player
display the video content stored in the USB memory stick on the display automatically.
STEP 1 :
To enable the Media Failover function on the OSD menu under 'Setup' page > 'Fail Over' to 'ON' as shown
below :
STEP 2 :
Stored the media content in the following format in the USB memory stick and
Supported media format file : "MP4"
STEP 3 :
The built-in media player will run and display the video content stored in the USB memory stick
automatically if the video input source is no signal / loss of sync on a designated input.
Note: It will not automatically change to any input that it must be selected via OSD button or serial command or
power cycle the controller.
STEP 4 :
If you want to go back to display the input signal such as HDMI1, press 'MENU' button on the OSD switch
mount to trigger the input source selection menu displayed on screen as shown below. Then select the input source
you want to jump back. Or just power cycle the controller to switch back.
Stored media
content in
USB memory
stick
USB extend cable
P/N 426895100-3
P5
