- 18 -
- 19 -
OLS-3250LA | OLS-4240LL | OLS-4650LA | OLS-5541LL
6. How to Connect Cables
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB cable.
Connect the Power Cable to the monitor first and then to the power supply.
Turn on your monitor (Main Power Switch and Power Switch) and computer.
- The signal cables used for connecting the computer an d monitor may vary with the type of computer used.
An incorrect connection may cause serious damage to both the monitor and the computer. The cable
supplied with the monitor is for a standard connector. If a special cable is required please contact your
local dealer or regional office.
- For connection to Macintosh computers, contact your local dealer or regional o ffice for a suitable adaptor.
- Make sure you tighten the finger screws at each end of the Signal Cable.
- Don
’
t connect the RS-232C cable and the USB cable to the computer at the same time. And cannot use
those at the same time.
- When USB cable connected than wait for 8 seconds and the touch function is ready to go. It can be
activated by pen, finger or any other pointer.
NOTE
POWER
UP
DOWN
AUTO/EXIT
SOURCE/OK
MENU
LED
IR
USB
COM IN
HDMI IN
DVI IN
VGA IN AUDIO IN IR
AC IN
AV Equipment
Computer
HDMICable
HDMICable
RS-
232
C Cable
USB Cable
DVI-D Cable
VGA(D-sub) Signal Cable
Audio Cable
AUDIO
IN
IR
VGA
IN
DVI
IN
HDMI
IN
COM
IN
USB
AC
IN
