Digital Spectrum TMS320C6413, Technical Reference

Page: 42 / 78

Spectrum Digital, Inc
3-12 TMS320C6413/C6418 EVM Module Technical Reference
3.7.3 JP1, PLD Programming Connector
This connector interfaces to the Altera CPLD, U2. It is used in the in the factory for the
programming of the CPLD. This connector is not intended to be used outside the
factory.
3.8 P5, Keypad/Display Connector
The EVM supports a 16 pin 2 mm. connector which interfaces to the keypad/display
unit. The signals on the 8 x 2 connector are shown in the table below.
3.9 System LEDs
TheTMS320C6413/C6418 EVM has two system light emitting diodes (LEDs). These
LEDs indicate various conditions on the EVM. These function of each LED is shown in
the table below.
3.10 Reset Circuitry
There are three resets on the TMS320C6413/C6418 EVM. The first reset is the power
on reset. This circuit waits until power is within the specified range before releasing the
power on reset pin to the TMS320C6413/C6418.
External sources which control the reset are push button S1, and HPI Reset from the
expansion connector.
Table 7: System LEDs
Pin # Signal Pin # Signal
1 2 1
3 4 1
5 6
7 8
9 10
11 12
13 14
15 16
Table 8: System LEDs
Reference
Designator
Color Function
On Signal
State
DS6 Green +5 Volt present 1
DS5 Orange RESET Active 1