Digital Projection
M-Vision Cine 320 Series
OPERATING THE PROJECTOR
Installation and Quick-Start Guide
11
Rev D July 2014
Selecting an input signal or test pattern
Input signal
Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within two or
three seconds.
If more than one signal is connected, select the image you want to display in one of the following ways:
•
Access the
Main
menu (either from the remote control or from the control panel) and then go to
Input Select
.
•
On the remote control, select from the inputs using the number buttons
1
to
6
•
On the control panel, press
SOURCE
to cycle through all the inputs.
Test pattern
To display a test pattern, do either of the following:
•
Press the
TEST
button
TEST
on the remote control to cycle through all test patterns.
•
Access the
Service
menu and select a test pattern.
Notes
For full details of how to use the
controls and the menu system, see
the
Operating Guide
.
