Digital Projection HIGHLite1400HD, User Manual

Page: 24 / 96

E-24
AUDIO OUT
L R
Component
COMPONENT
Y Cb Cr
3
Making Connections
Connecting to the Image Input Terminals
This Projector has two interface boards, MM-VIDEO and MM-RGB as standard equipment. See page E-11. Connect required video
signals.
Four interface boards can be inserted in the Projector at the same time. See Page E-25.
Component video RCA
⳯
3 cable
(not supplied)
RCA(female)-to-BNC(male)
adapter (not supplied)
2. Installation
BNC
⳯
5 cable
(not supplied)
Projector
PC DVD player
Information for Reducing Radiation of Electromagnetic
Waves
To reduce unnecessary radiation of electromagnetic waves, use
the supplied ferrite clamp core.
• When cable is for RGB signal, ferrite core is assembled to the
both side of the cable.
• When cable is for DVI-D signal, ferrite core is assembled to
the side where ferrite core is not attached.
• When cable is for USB Remote Control, Used to connect the
remote controller input 1 port (REMOTE IN 1) and the remote
controller output port (REMOTE OUT) on HL12000HD/
HL10000HD. Or Ethernet For HL12000HD/10000HD - ferrite
core is assembled to the near side of this equipment.
Installation Instructions
1. Open the ferrite clamp core and attach it to the cable as close as pos-
sible to end that goes to the Projector.
* Push the catch to open the ferrite clamp core.
* Loop the cable once around the ferrite clamp core.
NOTE: When cable is thick, ferrite core is assembled without making a ring.
2. Close the ferrite clamp core tightly.
3. Fix the supplied band to the Ethernet cable as a stopper.
* Pull the end of the band to tighten it. Cut off the surplus of the band.
band
Ferrite clamp core (supplied)