System Setup
XR150FC/XR550FC User’s Guide
9
Resetting the Sensors
1. Access the User Menu.
2. Press COMMAND until SENSOR RESET displays.
3. The keypad displays SENSORS OFF for five seconds followed
by SENSORS ON.
4. The keypad automatically exits the User Menu.
Lockdown
Locks all Public Doors from the keypad in an emergency situation.
Using Lockdown
1. Access the User Menu.
2. Press COMMAND until LOCKDOWN? displays.
3. Press any Select key. The door access relay is activated and
all Public Doors are locked.
4. Press COMMAND to return to the Status List display.
Door Lock/Unlock
Locks and unlocks doors from the keypad.
Using Door Lock/Unlock
1. Access the User Menu.
2. Press COMMAND until DOOR LOCK/UNLOCK? displays.
3. Enter the door number and press COMMAND.
-OR-
Press the fourth Select Key to browse door names. Use the
COMMAND key to scroll through names and press any Select
Key when the desired door is displayed.
4. Press the Back Arrow key to return to the
DOOR LOCK/UNLOCK? display.
Alarm Silence
Silences the alarm bells or sirens during an alarm.
Alarm Silence allows you to turn off the alarm bells and sirens
connected to your system during an alarm. Using Alarm Silence does
NOT stop an alarm report from being sent to the central station and
does not reset any alarmed devices. Use the Sensor Reset function
to reset devices such as smoke detectors that latched in alarm.
Note:
The keypad tone silences as soon as the first user code digit
key is pressed. You can also silence an alarm by entering your user
code and pressing COMMAND or by presenting your card to a reader
while the Status List displays. If using a proximity card, areas
assigned to your card may be disarmed and door access occurs.
Using the Alarm Silence Function
1. Access the User Menu.
2. The keypad displays ALARM SILENCE?.
3. Press any Select key to silence the bells and exit the User
Menu.
Sensor Reset
Resets smoke or glassbreak detectors. Also clears Fire/Supervisory
alarm and trouble displays.
Sensor Reset is used to reset smoke and glassbreak detectors after
they have tripped. Once these detectors trip, they must be reset
before they can detect any additional alarm conditions. When you
select Sensor Reset, power to the detectors is temporarily removed
by the system allowing them to reset.
Make sure all smoke is cleared from around the smoke detector
areas before performing a Sensor Reset to prevent the alarm from
occurring again.