3
X1 ELEVATOR CONTROLLER QUICK START GUIDE | DIGITAL MONITORING PRODUCTS
DETERMINE COMMUNICATION
For more detailed information, follow the QR code at the end of this guide to see the
full X1 Series Elevator Controller Installation and Programming Guide: LT-2463.
Ethernet Connection
Connect an Ethernet cable from the LAN/WAN connection to the X1 Ethernet port.
Cellular Connection (Optional)
1.
Plug the included standoff into the Elevator Controller board.
2.
Plug the cell module onto the standoff.
3.
Plug the cell module into the cell header.
4. Screw on the cell module antenna cable to
the antenna connector.
5.
Run the cable around the 505-12 Power
Supply.
6. Attach the antenna with the nut on the
inside of the enclosure and the washers on
the inside and the top of the enclosure.
Wi-Fi Connection
If not connecting over Ethernet, the Elevator
Controller will connect over Wi-Fi after power up.
For installing the Wi-Fi Antenna, follow the QR code at the end of this guide to see the
full X1 Series Elevator Module Installation and Programming Guide: LT-2463.
Note:
You can connect over Ethernet or Wi-Fi, but not both at the same time.
Ethernet
Port
PoE
Headers
Cell
Header
Standoff
Location
APPLY POWER
Warning:
Refer to your local state regulations before connecting to building
power. Wiring methods shall be in accordance with NEC, NFPA #72, ANSI, and
with all Authority Having Jurisdiction.
Wire the Input Power
Connect the transformer wires to terminals 1 and 2 on the PCB. Ground yourself and
apply power to the Elevator Controller.
Wire the Battery
DMP recommends using a 9 Ah battery. Connect the black battery lead to the negative
battery terminal. Connect the red battery lead to the battery positive terminal.
Observe polarity when connecting the battery.